Specifications

Crestron CEN-SWPOE-16 16-Port Managed PoE Switch

Operations Guide – DOC. 7408B 16-Port Managed PoE Switch: CEN-SWPOE-16

•

Hardware Hookup

Make the necessary connections as called out in the illustration that follows this

paragraph. Refer to “Network Wiring” on page 6 before applying power. Apply

power after all connections have been made.

When making connections to the CEN-SWPOE-16, note the following:

• Use Crestron power supplies for Crestron equipment.

• The included cables cannot be extended.

Hardware Connections for the CEN-SWPOE-16 (Front View)

COMPUTER:

To Computer Console

Hardware Connections for the CEN-SWPOE-16 (Rear View)

1 - 16:

To PoE or Non-PoE

Network Devices

100-240V~50/60Hz

3.5-1.6A:

Power from Line Voltage

Ground

NOTE: Ensure the unit is properly grounded by connecting the chassis ground lug

to an earth ground (building steel).

NOTE: To prevent overheating, do not operate this product in an area that exceeds

the environmental temperature range listed in the table of specifications.

Label the Buttons

Use Crestron Engraver software to print custom labels for the CEN-SWPOE-16’s

front panel buttons and LEDs. Crestron recommends printing on 100-pound paper.

Paper weighing less than 100 pounds tends to crumple while sliding in, while paper

weighing more than 100 pounds may not fit.