Specifications

Crestron CEN-RGBHVHB High-Bandwidth RGB Matrix Switcher
Operations Guide – DOC. 7157C High-Bandwidth RGB Matrix Switcher: CEN-RGBHVHB • 41
Routing Signals
The VIEW button causes the display to show which input signals are routed to
which outputs. Pressing the VIEW button causes the LED above the button to light.
The display shows the “View Mode” screen.
NOTE: At initial startup, default signal routing is input 1 to output 1, input 2 to
output 2, etc.
“View Mode” Screen
IN1
OUT1
In View mode, pressing any of the numbered IN or OUT buttons causes the
corresponding LEDs to light, showing the input to output routing.
For example, if the IN button 1 is pressed, the LED above IN 1 lights and the LEDs
above any outputs input 1 is routed to also lights. Or, if the OUT 2 button is pressed,
the LED above OUT 2 lights and the light and the LED above the input that is routed
to OUT 2 also light.
If the A button is pressed while in View mode, its LED lights and the unit displays
the audio routing. If the V button is pressed while in View mode, its LED lights and
the unit displays the video routing.
Pressing the TAKE button toggles the unit to Route mode. In Route mode, the LED
above the VIEW button is not lit. The display shows the “Route Mode” screen.
“Route Mode” Screen
Route Mode
Press input/outputs
If the A button is pressed, its LED lights and audio signals can be routed. If the V
button is pressed, its LED lights and video signals can be routed. If both buttons are
pressed, both LEDs light and both audio and video signals can be routed
simultaneously.
To route signals, select A, V or both, then press the button for the input signal to
route, followed by the OUT buttons corresponding to the outputs to route that signal
to. Audio and video signals can be routed independently.
The LED below TAKE blinks on and off. Press the TAKE button to execute the
routing that has been selected. The TAKE LED stops blinking when routing changes
have been executed.
To exit View or Route mode, press the MENU button.