Specifications

High-Bandwidth RGB Matrix Switcher Crestron CEN-RGBHVHB
16 • High-Bandwidth RGB Matrix Switcher: CEN-RGBHVHB Operations Guide – DOC. 7157C
Stacking
Four “feet” are provided with the CEN-RGBHVHB so that if the unit is not rack
mounted, the rubber feet can provide stability when the unit is placed on a flat
surface or stacked. These feet should be attached prior to the hookup procedure.
Refer to the following illustration for placement of the feet.
Foot Placement for the CEN-RGBHVHB
Place Feet In Corners
NOTE: No more than two CEN-RGBHVHB units should be stacked.
Hardware Hookup
Connect the Device
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to “Network Wiring” on page 13
before attaching the 4-position
terminal block connector. Apply power after all connections have been made.
When making connections to the CEN-RGBHVHB, note the following:
• Use Crestron power supplies for Crestron equipment.
• The included cable cannot be extended.