Installation guide

Network Video Streamer Crestron CEN-NVS200
78
•
Network Video Streamer: CEN-NVS200 Operations & Installation Guide – DOC. 7111E
Uploading and Upgrading
Crestron recommends using the latest programming software and that each device
contains the latest firmware to take advantage of the most recently released features.
However, before attempting to upload or upgrade it is necessary to establish
communication. Once communication has been established, files (for example,
firmware) can be transferred to the control system (and/or device). Finally, program
checks can be performed (such as changing the device ID or creating an IP table) to
ensure proper functioning.
NOTE: Crestron software and any files on the website are for authorized Crestron
dealers and Crestron Service Providers (CSPs) only. New users must register to
obtain access to certain areas of the site (including the FTP site).
Establishing Communication
Use Crestron Toolbox for communicating with the CEN-NVS200; refer to the
Crestron Toolbox help file for details. There is a single method of communication:
TCP/IP communication.
NOTE: Required for operation with a Crestron control system.
Ethernet Communication
CEN-NVS200
PC Running
Crestron Toolbox
LAN
AUDIO
IN OUT
MEMORY
HW
R ESET
CE N -NV S 200
Ethernet Communications (Without Hub or Router)
PC Running
Crestron Toolbox
LAN
Power
Injector
CREST
R
ON
CEN-S
W-POE-5 Power over Ethe rnet Switch
Uplink
PoE
1
2
3
4
48VDC
Po wer
120 Volts
POE
CEN-NVS200
AUDIO
IN OUT
MEMO
RY
HW
R ESET
CE N -NV S 200
The CEN-NVS200 connects to PC via Ethernet:
1. Use the Device Discovery Tool (click the
icon) in Crestron Toolbox to
detect all Ethernet devices on the network and their IP configuration. The
tool is available in Toolbox version 1.15.143 or later.
2. Click on the CEN-NVS200 to display information about the device.