Installation guide

Crestron CEN-NVS200 Network Video Streamer

Operations & Installation Guide – DOC. 7111E Network Video Streamer: CEN-NVS200

•

6. In the Trigger pane, click one of the following radio buttons to set the

trigger type:

• Video Motion Detection, which is configured on the “Motion

Detection” page (refer to “Configuring Motion Detection Settings”

which starts on page 53 for information)

• Periodically. If selected, enter the time interval in minutes at which the

event is to be triggered

• Digital Input, which monitors digital input

• System Boot, which triggers the event when the CEN-NVS200 boots

• Recording notify, which triggers when the recording fails due to

running out of space or if the recording is overwriting old data

• Camera Tampering Detection, which triggers the event when camera

tampering is detected

• Video Loss, which triggers the event when the CEN-NVS200 does not

receive the video signal from the camera

• Video Sync, which triggers the event when the CEN-NVS200 receives

the video signal from the camera

7. In the Event Schedule pane:

• Select the day(s) of the week that the event is to occur.

• Select the time of the event: Always or enter the desired time interval in

hh:mm format.

8. In the Action pane, use the Trigger digital output for text entry box to enter

the number of seconds to trigger digital output when an event is triggered.

NOTE: It is recommended that different media be used in different events

to ensure that all media be produced and received properly.

If the same media is used in different events and the events trigger almost

simultaneously, the server(s) in the second triggered event do not receive

any media but receive notifications only.

9. Click Save to save the settings.

The event name, status, weekly schedule, time schedule and trigger type are

displayed in the Event Settings pane of the “Events and Servers”

configuration page. In the sample screen below, one event named

MotionDetect was added.

“Events and Servers” Configuration Page – Sample Event Settings Pane

To delete an event listed in the Event Settings pane, select the event in the

drop-down list and click Delete.