Installation guide

Network Video Streamer Crestron CEN-NVS200
58
•
Network Video Streamer: CEN-NVS200 Operations & Installation Guide – DOC. 7111E
• Up: Tilts the camera upward.
• Down: Tilts the camera downward.
• Home: Positions the camera to the center.
•
- (left side of Zoom): Allows the camera to zoom out.
•
+ (right side of Zoom): Allows the camera to zoom in.
•
- (left side of Focus): Controls the focus near function.
• Focus: Controls the focus function.
•
+ (right side of Focus): Controls the focus far function.
In addition, PTZ functions can be controlled by selecting the desired value from the
following drop-down lists:
• Pan speed: Controls the range of the horizontal movement of the camera.
The greater the value, the greater the angular movement when performing
the Left or Right functions.
• Tilt speed: Controls the range of the vertical movement of the camera. The
greater the value, the greater the angular movement when performing the
Up or Down functions.
• Zoom speed: Controls the range of the zooming. The greater the value, the
greater the change in viewing angle.
Preset Function Area: Identifies and saves the current video view as a preset
location and also sets patrol stops:
• Patrol selection: Provides a list of preset positions that corresponds to the
Preset Position: drop-down list and allows selection of desired preset
positions to be set as patrol stops:
⇒ Preset locations: From the list of preset positions, highlight the
desired position to be set as a patrol stop, then click Select. Up to 20
preset positions can be set as patrol stops.
⇒ Selected locations: Provides a list of preset positions selected as patrol
stops:
• To remove a preset position from the list of patrol stops, click
Remove.
• To move a preset position upward in the list of patrol stops, click
Up.
• To move a preset position downward in the list of patrol stop, click
Down.
To save the patrol selections, click Save.
• Dwelling time (sec): Specifies the number of the seconds for the following:
⇒ The stop time of each preset location during auto patrol of the camera.
⇒ The stay time at the leftmost and rightmost positions when the camera
is auto panning.
In the Dwelling time (sec): text entry box, enter the desired number of
seconds, and then click Save in the bottom of the page to save the setting.