Installation guide

Crestron CEN-NVS200 Network Video Streamer

Operations & Installation Guide – DOC. 7111E Network Video Streamer: CEN-NVS200

•

Configuring Motion Detection Settings

To configure motion detection settings, click Configuration on the CEN-NVS200

home page and then click Motion Detection in the column on the left side of the

page. The “Motion detection” configuration page opens.

“Motion Detection” Configuration Page

NOTE: The “Motion detection” configuration page can also be accessed by

entering the following URL in the web browser:

http://Video Streamer/setup/motion.html

Video Streamer is the host name or IP address of the CEN-NVS200.

1. Select the Enable motion detection checkbox to enable motion detection

window(s).

NOTE: A maximum of three windows can be created.

2. Click New to open a motion detection window:

• To adjust the size of the window, drag the top, bottom, left and right

edges of the window frame as desired.

• To move the window to the desired location for motion detection, click

the title bar and drag the window.

• To delete the window, click X in the upper right corner of the window.

3. In the Window Name text entry box, enter a name for the window. The

name is displayed in the title bar of the window.

4. Drag the Sensitivity slider to the desired percentage to set the motion

degree, that is, the endurable difference between two sequential images.

A higher sensitivity allows easier motion detection.

5. Drag the Percentage slider to the desired percentage to set the space ratio of

moving objects in the monitoring window. A smaller percentage allows

easier motion detection.