Installation guide

Network Video Streamer Crestron CEN-NVS200
48
•
Network Video Streamer: CEN-NVS200 Operations & Installation Guide – DOC. 7111E
7. (Optional) Select the Enable time shift caching stream checkbox to enable
this function.
8. Do any or all of the following:
• Click the Image Settings button to enter image settings. Refer to
“Configuring Image Settings” below for information.
• Click the Privacy Mask button to block one or more areas of the video
from being viewed on the video output. Refer to “Configuring Privacy
Mask Settings” which starts on page 49 for information.
• Configure video settings for Stream 1, Stream 2, Stream 3 and/or
Stream 4. Refer to “Configuring Video Quality Settings” which starts
on page 50 for information.
9. Click Save at the bottom of the “Audio and Video” configuration page to
save changes to video settings.
Configuring Image Settings
Configure image settings by pressing the Image Settings button in the Video
Settings pane of the “Audio and Video” configuration page. The “Image Settings”
configuration page opens.
“Image Settings” Configuration Page
NOTE: The “Image Settings” configuration page can also be accessed by entering
the following URL in the web browser:
http://Video Streamer/setup/image.html
Video Streamer is the host name or IP address of the CEN-NVS200.
On the “Image Settings” configuration page, adjust the Brightness, Saturation,
Contrast and Sharpness as desired. Values in the drop-down lists range from –5 to
+5.
NOTE: A value of 0 for Brightness and Contrast auto tunes the video.