Installation guide

Crestron CEN-NVS200 Network Video Streamer

Operations & Installation Guide – DOC. 7111E Network Video Streamer: CEN-NVS200

•

Refer to the following system configuration guidelines.

System: Set system parameters as follows:

• In the Host Name: text box, modify the default host name, CEN-NVS200,

using a unique name to identify the CEN-NVS200. The name appears on

the CEN-NVS200 home page and in the Device Discovery Tool of

Crestron Toolbox.

• If desired, disable the power and network LEDs on the front of the unit by

selecting the Disable Power and Network LEDs checkbox. By default, the

Disable Power and Network LEDs checkbox is deselected; the LEDs are

enabled.

System Time: Set system time parameters if the CEN-NVS200 is to be used without

a Crestron control system:

NOTE: System time control settings are not necessary when used with a Crestron

control system. The CEN-NVS200 system time automatically synchronizes with the

system time of the control system each time the CEN-NVS200 connects to the

control system.

• Keep current date and time: Keeps the current date and time of the

CEN-NVS200. An internal real-time clock maintains the date and time even

when the power of the system is turned off. After syncing with the

computer time or a manual time setting, this option is reselected.

• Synchronize with computer time: Synchronizes the date and time of the

CEN-NVS200 with the local PC. The read-only date and time of the PC is

displayed as updated.

• Manual: Adjusts the date and time according to the time entered by the

Administrator. The date must be entered in yyyy/mm/dd format. The time

must be entered in hh:mm:ss format.

• Automatic: Synchronizes the date and time of the CEN-NVS200 with the

assigned NTP server over the Internet whenever the CEN-NVS200 starts.

Synchronization fails if the assigned time server cannot be reached.

DI and DO: Set digital input and digital output settings as follows:

• Digital Input: From the drop-down list, select High or Low to define the

normal state of the digital input.

• Digital Output: From the drop-down list, select Grounded or Open to

define the normal state of the digital output.

• Hide Digital Output Controls: Select the checkbox to remove the Digital

Output controls (ON and OFF) from the home page. Deselect the checkbox

to show the Digital Output controls.

Click Save to save the changes.