Installation guide

Network Video Streamer Crestron CEN-NVS200

•

Network Video Streamer: CEN-NVS200 Operations & Installation Guide – DOC. 7111E

NOTE: If the default HTTP port number of 80 has been changed, the port

number must be appended to the IP address by entering a colon followed by

the new port number. If, for example, the IP address is 192.168.10.225 and

the HTTP port number has been changed from 80 to 150, enter

http://192.168.10.225:150.

For information about changing the HTTP port number, refer to

“Configuring Network Settings” which starts on page 32

3. If necessary, perform either of the following:

• For initial access to the CEN-NVS200 using Internet Explorer, there

may be a prompt for permission to install a new plug-in for the

CEN-NVS200. Click Yes to proceed. If Internet Explorer does not

allow continuing installation of the plug-in, check the Internet security

option and lower the security levels or contact the IT or networking

supervisor for assistance. The plug-in must be installed to display the

video in the web browser.

NOTE: The Internet Explorer request to install a plug-in for the

CEN-NVS200 depends on the Internet security settings of the PC. If

the highest security level is set, the PC may prohibit any installation

and execution attempt.

• For initial access to the CEN-NVS200 using Firefox, install the

QuickTime

media player.

The user name and password window opens, allowing log in to the

CEN-NVS200. Refer to “Logging In to the CEN-NVS200” on page 19 for

log-in information.

Using Crestron ToolBox

NOTE: To be able to use Crestron Toolbox to access the CEN-NVS200, the UPnP

(Universal Plug and Play) Ethernet protocol configuration setting of the

CEN-NVS200 must be enabled. The UPnP protocol is enabled by default. For

additional information, refer to “

Configuring Network Settings” which starts on page

To access the CEN-NVS200 from Crestron Toolbox:

1. Open Crestron Toolbox.

2. From the Tools menu, select Device Discovery Tool.

NOTE: The Device Discovery Tool can also be accessed by clicking the

Device Discovery Tool button ( ) in the toolbar.

NOTE: The security software running on the computer may send a

program alert regarding the attempt by Crestron Toolbox to connect to the

network. The connection must be allowed so the Device Discovery tool can

be used.

3. From the device list on the left-hand side of the screen, select the UPnP

name of the CEN-NVS200. The default UPnP name is CEN-NVS200.