Installation guide

Network Video Streamer Crestron CEN-NVS200
12
•
Network Video Streamer: CEN-NVS200 Operations & Installation Guide – DOC. 7111E
2. Refer to the following table for LED status indications.
LED STATUS DESCRIPTION
Red on Power on and system booting
Red off Power off
Red on + green blinking every second Network works (heartbeat)
Red on + green off Network fail
Red on + green blinking every two seconds Audio mute (heartbeat)
Red blinking every 0.15 second
+ green blinking every second
Upgrading firmware
Red blinking every 0.15 second
+ green blinking every 0.15 seconds
Restore default
3. All ports referenced to ground (G terminal). Do not connect anything to the X terminals.
4. The P O I G X X + - connections use a spring clamp. Press the orange lever to release the clamp, then
insert the wire. Wire ends should be stripped 3/8” (~ 9 mm) and inserted completely.
5. To reset the CEN-NVS200, press and release the recessed HW RESET button with a paper clip or
thin object. Wait for the video server to reboot. To restore the CEN-NVS200 to its factory default
settings, press and hold the recessed button until the NET and PWR LEDs blink rapidly. This takes
about 30 seconds. Upon successful restore, the LEDs revert to their normal operation (refer to the
table in footnote #2 above).