Installation guide

Network Video Streamer Crestron CEN-NVS100
Configuring Event Settings
Up to three events can be configured.
NOTE: If using the CEN-NVS100 with a Crestron control system, event parameters
are programmed automatically the first time the CEN-NVS100 connects to the
control system.
To configure an event:
1. In the Event Settings pane of the “Events and Servers” page, click Add.
The “Event Settings” page opens.
“Event Settings” Page
2. In the Event name: text entry box, enter a unique name for the event.
3. Select the Enable this event checkbox to enable the event.
4. In the Priority: drop-down list, select the priority of the event: High, Normal,
or Low. The event with the highest priority is executed first.
5. Enter the number of seconds to wait before detecting the next event (applicable
to motion detection and digital input trigger types).
6. In the Trigger pane, click one of the following radio buttons to set the trigger
type:
• Video Motion Detection, which is configured on the “Motion
Detection” page (refer to “Configuring Motion Detection Settings” on
page 45 for information)
• Periodically. If selected, enter the time interval in minutes at which the
event is to be triggered.
58 • Network Video Streamer: CEN-NVS100 Operations & Installation Guide – DOC. 6873A