Installation guide

Crestron CEN-NVS100 Network Video Streamer
NOTE: The string of characters must conform to that of the external FTP
server. Some FTP servers cannot accept a preceding slash symbol before
the path without virtual path mapping. Refer to the FTP server
documentation for details.
NOTE: The folder privilege must be open for upload.
Passive Mode: Select the checkbox to enable Passive mode transmission.
Passive mode allows the flow of data to be set up and initiated by the
CEN-NVS100 (FTP client) rather than by the FTP server.
HTTP configuration:
URL: Enter the URL to upload the media.
User Name: Enter the granted user name on the external HTTP server.
Password: Enter the granted password on the external HTTP server.
Network storage configuration:
Network Storage Location: Enter the path to upload the media.
NOTE: Only one network storage is supported.
Workgroup: Enter the workgroup for network storage.
User Name: Enter the granted user name on the network storage.
Password: Enter the granted password on the network storage.
Crestron Control System configuration:
Server Address: Enter the domain name or IP address of the Crestron
control system.
Server Port: Enter the port number of the CEN-NVS100 module.
5. Click Test to test whether the settings are correct. A window opens displaying
the test result.
6. Close the window displaying the test result.
7. If the settings are correct, click Save; otherwise, enter the correct information,
test it, and then click Save.
The server name, type, and address/location are shown in the Server Settings
pane on the “Events and Servers” configuration page. In the sample screen
below, one server named Server1 was added.
“Events and Servers” Configuration Page – Sample Server Settings Pane
To delete a server listed in the Server Settings pane, select the server in the drop-
down list and click Delete.
Operations & Installation Guide – DOC. 6873A Network Video Streamer: CEN-NVS100 • 55