Installation guide

Network Video Streamer Crestron CEN-NVS100
• Patrol selection: Provides a list of preset positions that corresponds to the
Preset Position: drop-down list and allows selection of desired preset
positions to be set as patrol stops:
⇒ Preset locations: From the list of preset positions, highlight the
desired position to be set as a patrol stop and then click Select. Up
to 20 preset positions can be set as patrol stops.
⇒ Selected locations: Provides a list of preset positions selected as
patrol stops:
• To remove a preset position from the list of patrol stops,
click Remove.
• To move a preset position upward in the list of patrol
stops, click Up.
• To move a preset position downward in the list of patrol
stop, click Down.
To save the patrol selections, click Save.
NOTE: As mentioned above, you must click Save to save the Dwelling time and
Patrol selection settings. If you do not click Save, the Dwelling time and Patrol
selection settings do not take effect.
Setting Custom Commands
Set custom commands by pressing the Custom Command button on the “Camera
Control” configuration page. The “Custom Command” configuration page opens.
NOTE: Up to five custom commands can be set.
NOTE: If you selected Custom camera as the PTZ driver on the “Camera Control”
configuration page, you must configure pan, tilt, zoom, and focus functions by
setting custom commands.
“Custom Command” Page (Not Applicable to Custom Camera)
50 • Network Video Streamer: CEN-NVS100 Operations & Installation Guide – DOC. 6873A