Installation guide

Crestron CEN-NVS100 Network Video Streamer
Camera Control Area: In the camera control area, click one of the following
buttons to control PTZ camera functions:
• Left: Pans the camera to the left.
• Right: Pans the camera to the right.
• Up: Tilts the camera upward.
• Down: Tilts the camera downward.
• Home: Positions the camera to the center.
•
- (left side of Zoom): Allows the camera to zoom widely.
•
+ (right side of Zoom): Allows the camera to zoom telescopically.
•
- (left side of Auto Focus): Controls the focus near function.
• Auto Focus: Controls the auto focus function.
•
+ (right side of Auto Focus): Controls the focus far function.
In addition, PTZ functions can be controlled by selecting the desired value from the
following drop-down lists:
• Pan speed: Controls the range of the horizontal movement of the camera.
The greater the value, the greater is the angular movement when performing
the Left or Right functions.
• Tilt speed: Controls the range of the vertical movement of the camera. The
greater the value, the greater is the angular movement when performing the
Up or Down functions.
• Zoom speed: Controls the range of the zooming. The greater the value, the
greater is the change in the viewing angle.
Preset Function Area: Identifies and saves the current video view as a preset
location and also sets patrol stops:
• Preset position name: In the text entry box, enter a short name for the
current video view, and the click Add.
NOTE: Entering a very long preset position name causes problems with
the positioning of the camera.
• Dwelling time (sec): Specifies the number of the seconds for the following:
⇒ The stop time of each preset location during auto patrol of the
camera.
⇒ The stay time at the leftmost and rightmost positions when the
camera is auto panning.
In the Dwelling time (sec): text entry box, enter the desired number of
seconds, and then click Save in the bottom center of the page to save the
setting.
• Preset Position: Provides a list of preset positions:
⇒ To move the camera to a certain preset position, select the desired
position from the drop-down list and then click Go to.
⇒ To delete a certain preset position, select the desired position from
the drop-down list and then click Delete.
Operations & Installation Guide – DOC. 6873A Network Video Streamer: CEN-NVS100 • 49