Installation guide

Network Video Streamer Crestron CEN-NVS100
2. (Applicable only when PTZ Camera is selected) In the Camera ID text
entry box, enter the ID specific to the camera. The camera ID is necessary
for multiple camera control. Refer to the PTZ camera documentation for ID
settings.
3. (Applicable only when PTZ Camera is selected) From the PTZ Driver:
drop-down list, select the desired PTZ driver. The CEN-NVS100 has three
built-in PTZ camera drivers: DynaDome/SmartDOME, Lilin PIH-7x00,
and Pelco D protocol. If desired, you can select Custom camera and
upload an alternative PTZ driver to the CEN-NVS100.
NOTE: If PTZ camera functions do not operate, refer to your PTZ camera
documentation to verify that the camera supports those functions.
NOTE: If you select Custom camera, refer to “Performing Maintenance
Actions” on page 63 for information about uploading your PTZ driver file.
In addition, you must configure pan, tilt, zoom, and focus functions by
setting custom commands. Refer to “Setting Custom Commands” on page
50 for additional information.
4. (Applicable only when PTZ Camera or Transparent HTTP Tunnel is
selected) From the Port Settings: drop-down list, select the desired baud
rate, data bits, stop bits, and parity bit.
5. Click Save.
To set preset positions and custom commands, refer to the sections that follow.
Setting Preset Positions
Configure preset positions by pressing the Preset Position button on the “Camera
Control” configuration page. The “Preset Position” configuration page opens.
“Preset Position” Page
To set presets, refer to the guidelines that follow.
NOTE: The CEN-NVS100 allows up to 20 preset locations.
48 • Network Video Streamer: CEN-NVS100 Operations & Installation Guide – DOC. 6873A