Installation guide

Crestron CEN-NVS100 Network Video Streamer
Configuring Camera Control Settings
To configure camera control settings, click Configuration on the CEN-NVS100
home page and then click Camera Control in the left-hand column of the page.
The “Camera Control” configuration page opens.
“Camera Control” Configuration Page
NOTE: The “Camera Control” configuration page can also be accessed by entering
the following URL address in your Web browser:
http://Video Streamer/setup/camera_control.html
Video Streamer is the host name or IP address of the CEN-NVS100.
1. Select one of the following radio buttons:
• Disable: Select Disable if the camera is a fixed camera or does not
support PTZ features. If Disable is selected, camera control
functions on the “Camera Control” page are not displayed.
• PTZ Camera: Select PTZ Camera to configure the camera ID,
camera driver, and RS-485 port settings.
• Transparent HTTP Tunnel: Select Transparent HTTP Tunnel for a
PTZ camera to allow the CEN-NVS100 to forward UART
commands. The UART commands are sent through the HTTP
tunnel established between the user and the CEN-NVS100 and are
transmitted to the device connected to the CEN-NVS100.
When Transparent HTTP Tunnel is selected, only RS-485 port
settings can be configured.
Operations & Installation Guide – DOC. 6873A Network Video Streamer: CEN-NVS100 • 47