Installation guide

Crestron CEN-NVS100 Network Video Streamer
Mute: Select the checkbox to disable audio if desired.
Input Gain: From the drop-down list, select the desired number of decibels (dB) to
modify the gain of the audio input.
Audio Type: Select AAC or GSM-AMR.
NOTE: Most cell phones support media streaming with GSM-AMR audio.
AAC Bit Rate: If AAC is selected as the audio type, set the AAC bit rate based on
available bandwidth.
GSM-AMR Bit Rate: If GSM-AMR is selected as the audio type, set the GSM-AMR
bit rate based on available bandwidth
Configuring Motion Detection Settings
To configure motion detection settings, click Configuration on the CEN-NVS100
home page and then click Motion Detection in the left-hand column of the page.
The “Motion detection” configuration page opens.
“Motion Detection” Configuration Page
NOTE: The “Motion detection” configuration page can also be accessed by
entering the following URL address in your Web browser:
http://Video Streamer/setup/motion.html
Video Streamer is the host name or IP address of the CEN-NVS100.
1. Select the Enable motion detection checkbox to enable motion detection
window(s).
NOTE: A maximum of three windows can be created.
2. Click New to open a motion detection window:
• To adjust the size of the window, drag the top, bottom, left, and
right edges of the window frame as desired.
• To move the window to the desired location for motion detection,
click the title bar and drag the window.
• To delete the window, click X in the upper right-hand corner of the
window.
Operations & Installation Guide – DOC. 6873A Network Video Streamer: CEN-NVS100 • 45