Installation guide

Network Video Streamer Crestron CEN-NVS100
Setup
Network Wiring
When wiring the Ethernet network, use CAT5 wiring. CAT5 wiring is a twisted pair
cable designed for Ethernet networks. These networks operate at speeds of up to 100
Megabits per second (Mbps) using the 100BaseT standard.
For information on connecting Ethernet devices in a Crestron system, refer to the
latest version of the Crestron e-Control
®
Reference Guide (Doc. 6052), which is
available for download from the Crestron website (www.crestron.com/manuals).
Supplied Hardware
The hardware supplied with a CEN-NVS100 is listed in the following table.
Supplied Hardware for a CEN-NVS100
DESCRIPTION PART NUMBER QUANTITY
Mounting Bracket 2022739 1
M3 x 5mm, Flat Head Phillips Screws 2022785 4
BNC-to-RCA-adapter 2022817 1
6-Pin Screw Terminal 2022818 1
Installation
Ventilation
A CEN-NVS100 should be used in a well-ventilated area. The venting holes should
not be obstructed under any circumstances. To prevent overheating, do not operate
this product in an area that exceeds the environmental temperature range listed in the
table of specifications.
Mounting
The CEN-NVS100 mounts onto a wall or a rack. The supplied mounting bracket
must be attached to the CEN-NVS100 before the device is mounted.
Attaching the Mounting Bracket
Attach the bracket to the bottom of the CEN-NVS100 using the four supplied
M3 x 5mm Phillips flat head screws as shown below.
Attachment of Mounting Bracket to CEN-NVS100
6 • Network Video Streamer: CEN-NVS100 Operations & Installation Guide – DOC. 6873A