Specifications

Crestron CAPTURE-HD/CAPTURE-HD-PRO High-Definition Capture Recorder
Operations Guide – DOC. 7233F High-Definition Capture Recorder: CAPTURE-HD/CAPTURE-HD-PRO • 21
Audio Parameters
• Ability to mix the audio from both the speech input as well as from the
content input, as shown in the following diagram.
• Ability to choose source of content audio. Default is Auto (picks HDMI if
present; otherwise uses unbalanced input).
NOTE: Auto mode does not include selection of the balanced audio input. If
this is needed, it must be directly selected.
Time
• The Capture recorder attempts to get the time from a national time server
upon boot-up. Menu options enable specific time sources.
• Select Fusion RV (default) to have Fusion RV server set the time.
• Select Control System to have a Crestron control system set the time.
• Select Network Time to have the Capture recorder use Network Time
Protocol to connect to internet servers to set the time.
Recording
• Media must be present in the default storage location in order for the
recording to start.
• After pressing the REC button there is an approximately 10 second
“preparing to record” process that needs to complete before the recording
actually starts.
• NEVER remove the media while a recording is in progress. (This action
could corrupt the file.)
• Press the PAUSE button to pause the recording (yellow PAUSE button
lights up). Press REC again to continue recording.
• Press the STOP button to end recording. Wait for a “Done” message to
appear before removing media.
Streaming
• With the streaming parameters defined, press REC to start streaming; the
button turns red while streaming.
• Press STOP to stop streaming. Press REC again to continue streaming.
Front Panel
• The “Front Panel Lock” menu enables the use of a password to prevent
unauthorized access. A custom password can be assigned with front panel
controls via the “PASSWORD” menu.