Specifications

Crestron CAPTURE-HD/CAPTURE-HD-PRO High-Definition Capture Recorder
Operations Guide – DOC. 7233F High-Definition Capture Recorder: CAPTURE-HD/CAPTURE-HD-PRO • 13
• If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the device in the rack.
NOTE: Observe the following guidelines when installing equipment in a rack:
• Elevated Operating Ambient Temperature - If installed in a closed or
multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient temperature. Therefore,
consideration should be given to installing the equipment in an environment
compatible with the maximum ambient temperature (Tma) specified by the
manufacturer.
• Reduced Air Flow - Installation of the equipment in a rack should be such
that the amount of airflow required for safe operation of the equipment is not
compromised.
• Mechanical Loading - Mounting of the equipment in the rack should be such
that a hazardous condition is not achieved due to uneven mechanical loading.
• Circuit Overloading - Consideration should be given to the connection of the
equipment to the supply circuit and the effect that overloading of the circuits
might have on overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be used when
addressing this concern.
• Reliable Earthing - Reliable earthing of rack-mounted equipment should be
maintained. Particular attention should be given to supply connections other
than direct connections to the branch circuit (e.g., use of power strips)
NOTE: If rack mounting is not required, rubber feet are provided for tabletop
mounting or stacking. Apply the feet near the corner edges on the underside of the
unit.
To install the ears, use the following procedure.
CAUTION: To prevent equipment damage, use only the rack ears Crestron provides
for this device.
1. There are screws that secure each side of the Capture recorder top cover.
Using a #1 or #2 Phillips screwdriver, remove the four screws closest to the
front panel from one side of the device. Refer to the diagram following step 3
for a detailed view.
2. Position a rack ear so that its mounting holes align with the holes vacated by
the screws in step 1.
3. Secure the ear to the device with four of the eight longer screws supplied, as
shown in the following diagram.