Datasheet

Appendix 1
3 (4)
Step 4: Checking equipment
Check that all connections, cables and equipment are working
4a: Make sure all cables are connected to the camera
- The camera is turned on and has enough battery power
- The camera is placed in the correct place, and the angle is right
- Above all else, make sure an SD memory card is inside the camera
4b: Check that the webcam and microphone are connected to the computer and Adobe
ConnectPro is open and logged in
- Select a room in ConnectPro
- Click the webcam and microphone settings on the left side of the mid-
dle bar
- Accept the Flash-request to access microphone and webcam settings
- Check the positioning of the webcam in regards to the lecturer
- Check the volume levels of the microphone
- Open required PowerPoint slides
- Select Picture-in-Picture mode
- Make sure to tick the Publish checkbox and the Private or General op-
tion is selected
- Share the URL-link to the room
- Start recording
Step 5: Record
Step 5a: Start recording at the start of the lecture.
- Pause the recording, if a break is needed.
- Remember to continue recording once the break is over
- Stop recording at the end of the lecture
Step 5b: Start recording at the start of the lecture
- Pause the recording if a break is needed
- Remember to continue recording once t
- End recording at end of lecture