Installation guide

Cameo Keypads Crestron C2N/C2NI-CB Series
26 • Cameo Keypads: C2N/C2NI-CB Series Operations & Installation Guide - DOC. 6560B
Program
Manager
Program Manager is the view where programmers “program” a Crestron
control system by assigning signals to symbols.
The symbol can be viewed by double-clicking on the icon or dragging it
into Detail View. Each signal in the symbol is described in the SIMPL
Windows help file (F1).
Button Locations
The following illustration demonstrates the available button locations,
left (L), right (R), and center (C) button press options, and feedback
LEDs on the keypad.
Cameo Keypad Button and Feedback LED Arrangement
Button Location 1Feedback 1 (fbck1)
Feedback 6 (fbck6)
Button Location 2
Button Location 3
Button Location 4
Button Location 5
Button Location 6L C R
L C
R
L
C R
L C R
L C R
L
C R
Reverse Button Locations
In cases where it is desirable to mount the keypad with the feedback
LEDs on the right, programmers will have to take into account that
physically, button 6 is now at the top, button 1 is at the bottom, and that
the right and left switch positions are reversed. Bear in mind, however,
that when combining buttons in this orientation, the usual programming
constraints still apply. For example, if merging buttons 4, 5, and 6, even
though button 6 is now physically at the top of the keypad, button 4 still
controls the mode of the merged buttons.