Installation guide
Crestron C2N/C2NI-CB Series Cameo Keypads
Operations & Installation Guide - DOC. 6560B Cameo Keypads: C2N/C2NI-CB Series • 21
Mounting Using Screws Through the Bezel
Refer to the figure on the next page and do the following.
1. Drill pilot holes through the bezel from the rear at each of the
drill center points. Then, from the front of the bezel, drill the
final holes and countersink as required. (Refer to C in the
following figure.)
2. Place the plastic wall plate over the keypad with the smooth
surface facing out, and snap the wall plate and bezel together.
3. Attach the keypad to the mounting surface or to the back box
using the appropriate screws.
4. Turn the Cresnet system power ON.
If the keypad needs to be removed from the wall, remove the screws
securing the keypad to the mounting surface/back box, and pull the
keypad free.
UK Mounting Options
Screws
(not supplied)
Plastic
Wall Plate
C2NI-CBUK
Plastic
Wall Plate
Back Box
(typical)
Screws
(supplied)
Drill
Centerpoint (2)
Bezel
(Rear View)
A
B
C