Installation guide

Cameo Keypads Crestron C2N/C2NI-CB Series

20 • Cameo Keypads: C2N/C2NI-CB Series Operations & Installation Guide - DOC. 6560B

3. Insert the keypad into the hole and press the bezel against the

plastic wall plate until it snaps securely into position.

4. Turn the Cresnet system power ON.

If the keypad needs to be removed from the wall, there are two slots on

one edge of the bezel (visible on the bottom edge of view C in the figure

on page 21). Use a flat blade screwdriver to pry the bezel away from the

wall plate, being careful to avoid damage to the bezel.

Mounting to a UK Back Box

Prepare the hole in the wall appropriate for the back box. (Back boxes for

these keypads are typically square or rounded and have tabs with screw

holes for mounting the keypads on each side rather than top and bottom.)

After the Cresnet network wiring has been installed and verified, use the

following procedure to install the keypad in the back box.

1. Put the plastic wall plate in position over the back box and

attach using the supplied 7/8 in. pan head screws. (Refer to B in

the figure on page 21.)

2. Turn Cresnet system power OFF, and connect the Cresnet cable

to the keypad’s Cresnet port, using the supplied mating