Installation guide

Crestron C2N/C2NI-CB Series Cameo Keypads
Operations & Installation Guide - DOC. 6560B Cameo Keypads: C2N/C2NI-CB Series • 19
3. Hold the bezel and rear housing together and install and tighten
the two supplied Phillips pan head, 4-40 x 3/16” cover screws
(black), as shown in the illustration.
Button Caps
and Spacers
Bezel
LED
Holes
Cover
Screw
Rear Housing
and Switch
Assembly
Plastic Button
Suport
LED
Light
Pipes
4. Press each button to be certain that you feel the press and
release to ensure that the button caps move freely.
The keypad can be mounted directly to an appropriate surface or it can be
mounted to a back box. In both cases, you can choose to have mounting
screws visible or hidden.
Mounting to the Surface
Use the supplied template to prepare the hole in the wall. (Refer to the
Appendix on page 34 for an illustration of the template.) After the
Cresnet network wiring has been installed and verified, use the following
procedure to install the keypad in the prepared hole.
1. Put the plastic wall plate in position over the prepared hole and
attach using two screws (not supplied) appropriate for the
mounting surface. (Refer to A in the figure on page 21.)
2. Turn Cresnet system power OFF, and connect the Cresnet cable
to the keypad’s Cresnet port, using the supplied mating
connector.