Installation guide

Cameo Keypads Crestron C2N/C2NI-CB Series
18 • Cameo Keypads: C2N/C2NI-CB Series Operations & Installation Guide - DOC. 6560B
5. Attach the desired decorator style faceplate (not supplied).
6. Turn the Cresnet system power ON.
UK Mounting Installation
The keypad for UK mounting installation is supplied partially assembled
along with several items as listed in the following table.
Supplied Parts/Assemblies – UK Mounting
QTY ITEM DESCRIPTION
1 Rear housing and
switch assembly
Rear housing with switch circuitry
attached
1 Bezel Bezel assembly
1 Plastic wall plate Alternate mounting device and bezel
support
1 4-pin female mini
network connector
Used to connect Cresnet network cable
to the keypad
2 Screws, Black,
Phillips pan head,
4-40 x 3/16”
Used to attach the bezel assembly to the
keypad rear housing and switch
assembly
2 Single row spacer Switch cover for single non-operational
switch
1 Double row spacer Switch cover for two non-operational
switches
1 Triple row spacer Switch cover for three non-operational
switches
2 Screws, Steel,
Phillips, pan head,
6-32 x 7/8”
Used only to attach assembled keypad to
back box
Assemble the keypad as described in the following steps. Refer to the
accompanying illustration.
1. Place the button caps and/or spacers in position according to the
program plan. Attach the plastic button support to the button
caps/spacers, and put the assembled parts in place on the Rear
Housing and Switch assembly. (Refer to the illustration for the
standard mounting installation procedures, step 1, on page 16.)
2. Carefully position the bezel assembly, LED edge first, down
and over the button caps/blanks and rotate slightly into position
on the rear housing and switch assembly.