Installation guide

Cameo Keypads Crestron C2N/C2NI-CB Series
16 • Cameo Keypads: C2N/C2NI-CB Series Operations & Installation Guide - DOC. 6560B
Assemble the keypad as described in the following steps. Refer to the
accompanying illustrations.
1. Arrange the button caps
and/or spacers in position
according to the program plan.
Attach the plastic button
support to the button
caps/spacers, and put the
assembled parts in place on
the rear housing and switch
assembly.
2. Carefully position the bezel
assembly, LED edge first,
down and over the button caps/spacers and rotate slightly into
position on the rear housing and switch assembly.
Button Caps
and Spacers
Bezel
Assembly
Ground
Wire
LED
Holes
LED
Light
Pipes
Bracket
Rear Housing
and Switch
Assembly
Plastic Button
Support
Cover
Screw
3. Hold the bezel and rear housing together.
4. Install and tighten the two supplied Phillips pan head,
4-40 x 3/16” cover screws (black), as shown in the illustration.
5. Press each button to be certain that you feel the press and
release to ensure that the button caps move freely.