Installation guide

Crestron C2N/C2NI-CB Series Cameo Keypads
Operations & Installation Guide - DOC. 6560B Cameo Keypads: C2N/C2NI-CB Series • 15
careful to avoid damage to the wall surface, and use your
fingers to remove the keypad.
Standard Mounting Installation
The keypad for standard mounting installation is supplied partially
assembled along with several items as listed in the following table.
Supplied Parts/Assemblies – Standard Mounting
QTY
ITEM
DESCRIPTION
1 Rear housing and switch
assembly
Rear housing with switch circuitry
attached
1 Bezel assembly Bezel and metal plate assembly, with
ground wire
1 4-pin female mini network
connector
Used to connect Cresnet network
cable to the keypad
2 Screws, Black, Phillips
pan head, 4-40 x 3/16”
Used to attach the bezel assembly to
the keypad rear housing and switch
assembly
2 Single row spacer Switch cover for single non-
operational switch
1 Double row spacer Switch cover for two non-operational
switches
1 Triple row spacer Switch cover for three non-operational
switches
1 Plastic button support Used to hold the button caps/spacers
together in position
2 Screws, Steel, Phillips,
pan head, 6-32 x 7/8”
Used to attach the assembled keypad
to a back box