Installation guide
Cameo Keypads Crestron C2N/C2NI-CB Series
14 • Cameo Keypads: C2N/C2NI-CB Series Operations & Installation Guide - DOC. 6560B
6. Use the supplied template to prepare the hole in the wall. (Refer
to the Appendix on page 34 for an illustration of the template.)
NOTE: Be very careful when cutting the hole. There are no adjustments
for alignment with the spring clamp.
After the Cresnet network wiring has been installed and verified,
use the following procedure to install the keypad in the prepared
hole.
1. Turn Cresnet system power OFF.
2. Connect the Cresnet cable, using the supplied mating
connector, to the keypad’s Cresnet port.
3. Make sure the keypad is oriented properly and insert the keypad
in the hole. The natural action of the spring clamp holds the
keypad in position.
Slot
4. Turn Cresnet system power ON.
5. If the keypad needs to be removed from the wall, there is a slot
on one edge of the bezel (refer to the figure). Use a small flat
blade screwdriver to pry the keypad away from the wall, being