Installation guide

Cameo Keypads Crestron C2N/C2NI-CB Series
12 • Cameo Keypads: C2N/C2NI-CB Series Operations & Installation Guide - DOC. 6560B
Supplied Parts/Assemblies – Flush Mounting (Continued)
QTY ITEM DESCRIPTION
2 Single row
spacer
Switch cover for single non-operational switch
1 Double row
spacer
Switch cover for two non-operational switches
1 Triple row
spacer
Switch cover for three non-operational switches
1 Plastic button
support
Used to hold the button caps/spacers together
in position
1 Spring clamp Used to secure the assembled keypad in the
wall
1 Template Used to mark correct hole size in the wall
Assemble the keypad as described in the following steps. Refer to the
accompanying illustrations.
1. Place the button caps and/or spacers in position according to the
program plan. Attach the plastic button support to the button
caps/spacers, and put the assembled parts in place on the rear
housing and switch assembly. (Refer to the illustration for the
standard mounting installation procedures, step 1, on page 16.)
2. Carefully position the bezel assembly, LED edge first, down
and over the button caps/blanks and rotate slightly into position
on the rear housing and switch assembly.
3. Hold the bezel and rear housing together and install and tighten
the two supplied Phillips pan head, 4-40 x 3/16” cover screws
(black) into the rear housing and switch assembly, as shown in
the following illustration.
4. Press each button to be certain that you feel the press and
release to ensure that the button caps move freely.