Installation guide
Crestron C2N/C2NI-CB Series Cameo Keypads
Operations & Installation Guide - DOC. 6560B Cameo Keypads: C2N/C2NI-CB Series • 11
The button caps are tapered, and are often installed in a shingle-style
pattern (refer to the “C2N/C2NI-CB Series Keypad Physical Views”
illustration on page 4). Usual orientation of the keypad is with the LEDs
on the left. It can, however, be inverted with the LEDs on the right, but
the original relationship of the button numbers to the LEDs remains, i.e.,
with the unit inverted, row one is on the bottom – row six is on the top,
and programming of the switches would have to be done accordingly.
Installation consists of connecting the unit to the Cresnet system, and
then mounting it directly to the mounting surface or to a back box,
depending on the keypad configuration.
The following items are required for all installations:
• Cresnet network cable (not supplied)
• Cresnet 4-pin mating connector (supplied)
• No. 2 Phillips screwdriver (not supplied)
NOTE: Verify that you have sufficient Cresnet power to support your
net devices.
Flush Mounting Installation
The Cameo keypad for flush mounting installation is supplied partially
assembled along with several items as listed in the following table.
Supplied Parts/Assemblies – Flush Mounting
QTY ITEM DESCRIPTION
1 Rear housing and switch
assembly
Rear housing with switch circuitry
attached
1
Bezel
Bezel assembly
1 4-pin female mini network
connector
Used to connect Cresnet network
cable to the keypad
2 Screws, Black, Phillips
pan head, 4-40 x 3/16”
Used to attach the bezel assembly to
the keypad rear housing and switch
assembly
(Continued on following page)