Installation guide

Cameo Keypads Crestron C2N/C2NI-CB Series
10 • Cameo Keypads: C2N/C2NI-CB Series Operations & Installation Guide - DOC. 6560B
Setup
Network Wiring
When wiring the network, consider the following:
• Use Crestron Certified Wire.
• Use Crestron power supplies for Crestron equipment.
• Provide sufficient power to the system.
CAUTION: Insufficient power can lead to unpredictable results
or damage to the equipment. Please use the Crestron Power
Calculator to help calculate how much power is needed for the
system (
http://www.crestron.com/calculators).
• For larger networks, use a Cresnet Hub/Repeater (CNXHUB) to
maintain signal quality.
For more details, refer to “Check Network Wiring” on page 31.
Identity Code
The Net ID of the C2N/C2NI-CB Series keypad has been factory set to 25.
The Net IDs of multiple C2N/C2NI-CB Series devices in the same system
must be unique. Net IDs are changed from a personal computer (PC) via the
Crestron Toolbox™ (refer to “Establishing Communication” on page 28).
When setting the Net ID, consider the following:
• The Net ID of each unit must match an ID code specified in the
SIMPL Windows program.
• Each network device must have a unique Net ID.
For more details, refer to the Crestron Toolbox help file.
Assembly and Installation
Assembly of the keypad consists of placing the button caps/spacers in
position based on how the unit is programmed, securing them together
with a plastic button support, putting the button cap/spacer assembly in
place on the rear housing and switch assembly, and attaching the bezel.