Installation guide

Somfy Shade Controller Crestron C2N-SSC-2
Setup
Network Wiring
When wiring the network, consider the following:
• Use Crestron Certified Wire.
• Use Crestron power supplies for Crestron equipment.
• Provide sufficient power to the system.
CAUTION: Insufficient power can lead to unpredictable results or
damage to the equipment. Please use the Crestron Power Calculator to
help calculate how much power is needed for the system
(http://www.crestron.com/calculators
).
• For networks with 20 or more devices, use a Cresnet Hub/Repeater
(CNXHUB) to maintain signal quality.
For more details, refer to “Check Network Wiring” on page 19.
Identity Code
The Net ID of the C2N-SSC-2 has been factory set to 0C. The Net IDs of
multiple C2N-SSC-2 devices in the same system must be unique. Net IDs
are changed from a personal computer (PC) via the Crestron Toolbox™
(refer to “Establishing Communication” on page 14).
When setting the Net ID, consider the following:
• The Net ID of each unit must match an ID code specified in the
SIMPL Windows program.
• Each network device must have a unique Net ID.
For more details, refer to the Crestron Toolbox help file.
Installation
Installation consists of mounting the Shade Controller (using either the
Dual Lock fastener or screws, as desired) in a location that is out of
casual reach, but within 50 feet (15 m) of the shade(s) it controls;
connecting a Cresnet cable to the NET port; connecting the interface
cable(s) from the shade(s) to the RJ-11 port(s), and setting the upper and
6 • Somfy Shade Controller: C2N-SSC-2 Operations & Installation Guide - DOC. 6318B