Installation guide

Crestron C2N-FT-TPS4/TPS4-U FlipTop Touchpanel Control Center
Cutout Dimensions
TPS4 (4007478)
6.13 in
(15.56 cm)
7.25 in
(18.42 cm)
Max Radius
(0.125 in)
(0.32 cm)
NOTE: Before inserting the TPS4 in the mounting hole, ensure that all required
cables have been installed.
Mounting Parts Supplied with the TPS4
PART DESCRIPTION QUANTITY
Screw #6-32, Pan Head, Phillips 8
Screw #10, Pan Head, Phillips 4
Mounting Bracket 2
1. Install the eight supplied #6-32 screws, but do not tighten (four on the front
side and four on the rear side). These will be used to secure the front and
rear mounting brackets.
2. Position the TPS4 in the mounting hole. (Refer to the following graphic.)
Mounting Bracket Screw Locations
3. Install the four #10 screws in the mounting brackets (two screws per
bracket). Refer to the following diagram.
4. Slide the mounting brackets over the #6-32 screws and tighten the
#6-32 screws.
Operations & Installation Guide – DOC. 6398 FlipTop Touchpanel Control center: C2N-FT-TPS4/TPS4-U • 13