Installation guide

Crestron C2N-DBN12 & C2N-DBF12 Decorator Wall Panels

Operations & Installation Guide - DOC. 6200 Decorator Wall Panels: C2N-DBN12 & C2N-DBF12 • 25

Uploading a SIMPL Windows Program

A control

system source

ile has the

extension

.smw. A

compiled

SIMPL

Windows file

has the

extension .spz

or a 2-Series

control

system, .bin

or CNX

generation,

and .csz for

CNX

generation

with SIMPL+.

The SIMPL Windows file can be uploaded to the control system using

SIMPL Windows or via the Crestron Viewport.

Upload via SIMPL Windows

1. Start SIMPL Windows.

2. Select File | Open to view the “Open” window,

navigate to the SIMPL Window file (.smw), and

click Open.

3. Select Project | Transfer Program.

Upload via Crestron Viewport

1. Verify that the procedure for “Communication Settings” that

begins on page 21 has been performed.

2. As shown after this step, select File Transfer | Send Program

(alternatively, press Alt+P) from the Viewport menu bar.

File Transfer | Send Program Command

3. The “Send Program” window appears, as shown on the next

page. Click Browse, locate the compiled file (.spz for PRO2)

and click Open. This will display the program's header

information and enable one or both of the What to Send check

boxes. If the program does not contain any SIMPL+ modules,

only the SIMPL Program check box will be enabled. If it does

contain SIMPL+ modules, then the SIMPL+ Program(s) check

box will also be enabled. Select one or both check boxes and

then click Send Program to begin the transfer.

NOTE: Refer to the respective Operations Guide for the control system

for details about the other fields shown on the “Send Program” window.