Installation guide

Crestron C2N-DBN12 & C2N-DBF12 Decorator Wall Panels
Operations & Installation Guide - DOC. 6200 Decorator Wall Panels: C2N-DBN12 & C2N-DBF12 • 13
Installation
The following tools/hardware are required for installation.
• Cresnet network cable (not supplied)
• Phillips screwdriver (not supplied)
• Two 1-in. pan head Phillips screws (supplied)
After the Cresnet network wiring has been installed and verified, use the
following procedure to install the keypad in a standard, single-gang
electrical box (refer to illustrations on pages 5 and 6):
1. Turn Cresnet system power OFF.
2. Connect the Cresnet cable with supplied connector plug to the
keypad’s Cresnet port and the other end to the control system.
3. Make sure button unit is oriented as marked with arrow at top,
and place it in the electrical box.
CAUTION: Excess wire that is pinched between the keypad and
electrical box could short out. Make sure that all excess wire is
completely inside the electrical box and not between the box and the
keypad.
4. Attach the keypad to the electrical box using the supplied two
1-in. pan head screws.
5. Attach faceplate and divider.
6. Turn Cresnet system power ON.