Installation guide

Decorator Wall Panels Crestron C2N-DBN12 & C2N-DBF12
6 • Decorator Wall Panels: C2N-DBN12 & C2N-DBF12 Operations & Installation Guide - DOC. 6200
Installation View
Button Replacement
Replacing/changing the removable buttons in a wall panel is a simple
process. Refer to the illustrations above and the following procedures.
1. If the wall panel is installed in an electrical box, remove the two
1-inch securing screws, carefully pull the wall panel from the
electrical box, and disconnect the Cresnet cable.
2. Remove the four screws that attach the divider, and remove the
divider.
CAUTION: The removable buttons fit snugly on the rubber membrane
and must be removed carefully to avoid pulling the membrane from the
unit. Once the membrane is detached, you may be unable to reattach it.
3. While holding adjacent buttons in place, carefully pull the
button(s) to be replaced from the rubber membrane.