Installation guide

Decorator Keypads Crestron C2N-DB6, C2N-DB8 & C2N-DB12
Setup
Network Wiring
When wiring the Cresnet network, consider the following:
• Use Crestron Certified Wire.
• Use Crestron power supplies for Crestron equipment.
• Provide sufficient power to the system.
CAUTION: Insufficient power can lead to unpredictable results
or damage to the equipment. Use the Crestron Power Calculator to
help calculate how much power is needed for the system
(
www.crestron.com/calculators).
For Cresnet networks with 20 or more devices, use a Cresnet
Hub/Repeater (CNXHUB) to maintain signal quality.
For more details, refer to “Check Network Wiring” on page 16.
Identity Code
The Net
ID of the C2N-DB6/8/12 keypad has been factory set to 73, 72,
and 71
respectively. The NET IDs of multiple C2N-DB6/8/12 devices in
the
same system must be unique. Net IDs are changed from a personal
computer (PC) via the Crestron Toolbox
™
(refer to “Establishing
Communication” on page 13).
When setting the Net ID, consider the following:
• The Net ID of each unit must match an ID code specified in the
Crestron Studio™ or SIMPL Windows program.
• Each network device must have a unique Net ID.
For more details, refer to the Crestron Toolbox help file.
NOTE: The latest software can be downloaded at
www.crestron.com/software.
8 • Decorator Keypads: C2N-DB6/8/12 Operations & Installation Guide - DOC. 6154C