Installation guide

Crestron C2N-CBD-TS/C2N-CBF-T Cameo Keypads
Operations & Installation Guide - DOC. 6603D Cameo Keypads • 17
3. Hold the bezel and rear housing together.
4. Install and tighten the two supplied Phillips pan head,
2-28 x 3/16” cover screws (black), as shown in the illustration.
5. Press each button to be certain that you feel the press and
release to ensure that the button caps move freely.
After the Cresnet network wiring has been installed and verified, use the
following procedure to install the keypad in a standard, single-gang
electrical box (not supplied).
1. Turn Cresnet system power OFF.
2. Connect the Cresnet cable to the keypad’s NET port, using the
supplied mating connector.
3. Connect the contact-closure input cable, if any, using the
supplied mating connector, to the keypad’s INPUT port.