Installation guide

Cameo Keypads Crestron C2N-CBD-TS/C2N-CBF-T
16 • Cameo Keypads Operations & Installation Guide - DOC. 6603D
Standard Mounting Installation
The standard-mount Cameo keypad is supplied partially assembled along
with several items as listed in the following table.
Supplied Parts/Assemblies – Standard Mounting
ITEM
DESCRIPTION
QTY
Rear housing
assembly
Rear housing with switch circuitry
attached
1
Bezel assembly Bezel and metal plate assembly, with
ground wire
1
4-pin female mini
network connector
Used to connect Cresnet network cable
to the keypad
1
3-pin female mini
network connector
The cable is to be used to connect
contact closure to the keypad
1
Screws, Black,
Phillips pan head,
2-28 x 3/16”
Used to attach the bezel assembly to
the keypad rear housing and switch
assembly
2
Screws, Steel,
Phillips, pan head,
6-32 x 7/8”
Used to attach the assembled keypad to
an electrical box
2
Assemble the keypad as described in the following steps. Refer to the
accompanying illustration.
1. Arrange the button caps and/or spacers in position on the rear
housing assembly according to the program plan.
2. Carefully position the bezel over the button caps on the rear
housing assembly.