Installation guide

Crestron C2N-CBD-TS/C2N-CBF-T Cameo Keypads
Operations & Installation Guide - DOC. 6603D Cameo Keypads • 15
After the Cresnet network wiring has been installed and verified,
use the following procedure to install the keypad in the prepared
hole.
1. Turn Cresnet system power OFF.
2. Connect the Cresnet cable, using the supplied mating
connector, to the keypad’s NET port.
3. Connect the contact-closure input cable, if any, using the
supplied mating connector, to the keypad’s INPUT port.
4. Make sure the keypad is oriented properly and insert the keypad
in the hole. The natural action of the spring clamp holds the
keypad in position.
5. Turn Cresnet system power ON.
6. If the keypad needs to be removed from the mounting surface,
use a small flat blade screwdriver to pry the keypad away from
the mounting surface, being careful to avoid damage to the
mounting surface surface, and use your fingers to remove the
keypad.