Installation guide

Cameo Keypads Crestron C2N-CBD-TS/C2N-CBF-T
14 • Cameo Keypads Operations & Installation Guide - DOC. 6603D
3. Hold the bezel and rear housing together and install and tighten
the two supplied Phillips pan head, 2-28 x 3/16” cover screws
(black) into the rear housing assembly, as shown in the
following illustration.
4. Press each button to be certain that you feel the press and
release to ensure that the button caps move freely.
5. Use the supplied template to prepare the hole in the mounting
surface. (Refer to the Appendix on page 31 for an illustration of
the template.)
NOTE: Be very careful when cutting the hole. There are no adjustments
for alignment with the spring clamp. The optional MMK-CBF-T Mud
Mount Kit (purchased separately) may be used if the cutout in the
mounting surface is too large for the keypad.