Installation guide

Crestron C2N-CBD-TS/C2N-CBF-T Cameo Keypads
Operations & Installation Guide - DOC. 6603D Cameo Keypads • 13
Installation consists of connecting the unit to the Cresnet system,
connecting the contact closure input cable, if any, and then inserting the
unit into the mounting surface or attaching it to an electrical box,
depending on the keypad configuration.
The following items are required for all installations:
• Cresnet network cable (not supplied)
• Cresnet 4-pin mating connector (supplied)
• Contact closure input 3-pin mating connector (supplied)
• No. 2 Phillips screwdriver (not supplied)
NOTE: Verify that you have sufficient Cresnet power to support your
net devices.
Flush Mounting Installation
The flush-mount Cameo keypad is supplied partially assembled along
with several items as listed in the following table.
Supplied Parts/Assemblies – Flush Mounting
ITEM
DESCRIPTION
QTY
Rear housing assembly Rear housing with switch circuitry
attached
1
Bezel Bezel assembly 1
4-pin female mini
network connector
Used to connect Cresnet network
cable to the keypad
1
3-pin female mini
network connector
The cable is to be used to connect
contact closure to the keypad
1
Screws, Black, Phillips
pan head, 2-28 x 3/16”
Used to attach the bezel to the
keypad rear housing assembly
2
Template Used to mark correct hole size in the
mounting surface
1
Assemble the keypad as described in the following steps. Refer to the
accompanying illustration.
1. Place the button caps in position, according to the program
plan, on the rear housing assembly.
2. Carefully position the bezel over the button caps on the rear
housing assembly.