Specifications

Digital Graphics Engine Crestron DGE-2
Hardware Hookup
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to “Network Wiring” on page 18 before attaching the 4-position
terminal block connector. Apply power after all connections have been made.
When making connections to the DGE-2, use Crestron power supplies for Crestron
equipment.
Hardware Connections for the DGE-2 (Front View)
USB:
Computer
Console Port
Hardware Connections for the DGE-2 (Rear View)
AUDIO:
CAT5 Balanced
Stereo Input / Output
AUDIO IN:
Balanced / Unbalanced
Stereo Line Level Input
AUDIO OUT:
Balanced / Unbalanced
Stereo Line Level Output
USB:
To Mouse, Keyboard
or USB Flash Drive
MEMORY:
MMC Compatible
Card Slot
LAN:
10BASE-T / 100BASE-TX
Ethernet to LAN
Ground
REMOTE RESET:
From Contact Closure
Sensing Input
NET:
To Control
System
VIDEO IN - RGB:
RGB (VGA)
Video Input
VIDEO IN - HDMI:
Digital Video / Audio
Input
VIDEO IN -
Y / P
B
/Y / P
R
/C/COMP:
Analog Video Input
VIDEO OUT - HDMI:
Digital Video /
Audio Output
TO PANEL – D & M:
To V-Panel
DM CAT Input
TO PANEL – 24 A B G:
To V-Panel
DMNet Port
100-240V ~1.8A
50/60 Hz:
Main Power Input
48 • Digital Graphics Engine with DigitalMedia™ CAT Connectivity: DGE-2 Operations Guide – DOC. 6809E