Specifications

Digital Graphics Engine Crestron DGE-2
The initial position of the on-screen keyboard is determined by the VT Pro-e
®
program or SIMPL Windows settings. The on-screen keyboard defaults to its largest
size.
In use, when the on-screen keyboard is moved and/or resized and then closed, it
re-opens in the same position it was in and at the same size it was when closed. This
position and size remains in memory until the touch screen is re-booted or it is re-set
by the SIMPL Windows program. After reboot, the position of the on-screen
keyboard reverts to the defaults set in the VT Pro-e or SIMPL Windows program.
The size reverts to the largest as determined by the firmware installed in the touch
screen.
Exit the on-screen keyboard by selecting by touching the red close button in the
upper right corner of the keyboard window. If the Keyboard button on the start
menu is still visible, it can be touched to exit the keyboard.
VPanel Ethernet Status Details
NOTE: VPanel Ethernet Status is not displayed unless there is a V-Panel connected
directly to the DGE-2 DM OUT ports.
The VPanel Ethernet Status section of the setup menu provides a Link Status light to
indicate an Ethernet connection and displays the current IP and MAC addresses.
Touch VPG Config to open the “V-Panel Ethernet Configuration” window, shown
in the illustration below.
“V-Panel Ethernet Configuration” Window
When DHCP OFF is selected, IP Address, IP Mask, Default Router and MAC
Address can be entered manually.
44 • Digital Graphics Engine with DigitalMedia™ CAT Connectivity: DGE-2 Operations Guide – DOC. 6809E