Specifications

Crestron DGE-2 Digital Graphics Engine
LAN Ethernet Status Details
The LAN Ethernet Status section of the setup menu provides a Link Status light to
indicate a LAN Ethernet connection and displays the current LAN IP and MAC
addresses.
Standby Details
The Standby function turns off the backlight when the touch screen is inactive for a
specified time. Use the Up and Down buttons to set the Standby from 0 through 120
minutes, where 0 disables the timeout. Touch the screen to reactivate the touch
screen from standby mode. When the touch screen is reactivated, the last screen to be
displayed reappears.
NOTE: The hard buttons still function when the touch screen is in standby mode
but do not cause it to awaken from standby. The screen must be touched to reactivate
the touch screen.
Misc. Controls Details
The Misc. Controls section of the setup menu contains the Diagnostics and
Keyboard buttons.
Diagnostics
Touch Diagnostic to display the firmware version number, see Installed Packs and
to reset the end user license from the “Diagnostics” window.
“Diagnostics” Window
Reset CTP Port resets the default value of the CTP port to 41795, for terminal
connection using Crestron Toolbox.
To configure the appearance of popup messages, touch Configure Messages. The
“Message Popup Configuration” window opens.
Operations Guide – DOC. 6809E Digital Graphics Engine with DigitalMedia™ CAT Connectivity: DGE-2 • 41