Specifications

Digital Graphics Engine Crestron DGE-2
Connectors, Controls & Indicators (Continued)
#
CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
18
VIDEO IN (1 – 2)
Y P
B
/Y P
R
/C/COMP
Y
P
/
Y
B
P
/
CR
/CO
MP
(2) Auto-sensing, multi-format analog video
inputs, each comprised of (3) BNC female;
Signal types: component (YP
b
P
r
), S-video
(Y/C) or composite;
Input level: 1 V
p-p
nominal;
Input impedance: 75 Ω nominal
19
VIDEO OUT
HDMI
(1) 19-pin Type A HDMI female;
HDMI digital video/audio output;
Also supports DVI
2
Carries same audio and video signals as
DM OUT
20
TO PANEL
DM OUT, D & M
3
MD
(1) DM CAT output comprised of (2) 8-pin
RJ-45 female, shielded;
Connects to DM CAT input of a V-Panel
display via DB-CBL cable
4, 5
21
TO PANEL
DM OUT, 24 A B G
6, 7, 8
GBA24
(1) 4-pin 3.5 mm detachable terminal block,
DMNet port;
Connects to DMNet port of a V-Panel display
via DB-CBL cable
4, 5
22
100-240V ~1.8A
50/60 Hz
(1) IEC C14 male chassis plug;
Mates with detachable power cord, included
1. Interface connectors for AUDIO IN, AUDIO OUT, 24 A B G, REMOTE RESET and NET ports
are provided with the unit.
2. HDMI requires an appropriate adapter or interface cable to accommodate a DVI or DisplayPort
Multimode signal. CBL-HD-DVI interface cables available separately.
3. The DM OUT port consists of two separate RJ-45 connectors labeled D and M. The D port carries
HDMI signal. The M port carries data. Refer to the following table for the connector pinouts.
D and M Ports
18
PIN # WIRE COLOR PIN # WIRE COLOR
1 Orange/White 5 Blue/White
2 Orange 6 Green
3 Green/White 7 Brown/White
4 Blue 8 Brown
4. The V-Panel touch screen must be equipped with a DM CAT type interface for direct connection to
the DGE-2. Other V-Panel touch screens having a DM 8G+ interface may be connected to the DGE-2
through a DM-TX-201-transmitter or DigitalMedia switcher. Contact a Crestron representative for
additional design assistance.
16 • Digital Graphics Engine with DigitalMedia™ CAT Connectivity: DGE-2 Operations Guide – DOC. 6809E