Installation guide

User Interface Devices Crestron Adagio Entertainment System
4 • Adagio Entertainment System: User Interface Devices Out-Of-The Box Functionality Guide – DOC. 6493A
XM Tuner Status Screen
XM Tuner Control Screen
XM Tuner Presets Screen
XM Tuner Channels Screen
XM Tuner Categories Screen
XM Tuner Tech Display
Controlling XM Tuners
The XM tuner controls allow access to XM tuner functions such as presets,
categories, channels, and viewing radio signal strength.
On the XM tuner status screen, press the Control soft button to display the XM
tuner control commands as shown in the figure on the left.
• Press the Presets soft button to access the list of current preset stations.
Use the Nav Wheel to scroll through the list; press the Nav Wheel soft
button to enter a selection.
• To set a new Preset (or change an existing one), use the manual tuning
procedures to tune to a favorite station. Then, press the Preset soft button
and use the Nav Wheel to scroll through the list to the desired location and
press the Save soft button. The screen will display a prompt “Are you
sure you want to replace preset with . .” asking if you wish to replace
the current preset with the selected frequency. Press the OK soft button to
accept the replacement; press Cancel to reject it.
• The Disp soft button changes the display from radio stations, to artists, to
titles, and back to stations.
• Press the Chan soft button on the XM tuner control screen to display the
available channels (stations).
Use the Nav Wheel to scroll through the list; press the Nav Wheel soft
button to enter a selection.
• Press the Cat soft button to display the available categories.
Use the Nav Wheel to scroll through the list; press the Nav Wheel soft
button to enter a selection.
Press the Back soft button to return to the XM tuner Channels screen.
• Press the Tech soft button on the Control screen to display the signal
strength, in graphic form, of the selected station from the repeater and/or
from the satellite. The display also shows the radio ID. This information is
used during initial setup of the XM antenna and registering the XM radio,
as discussed in the latest version of the guide included with the tuner
(Doc. 6462).
iPod Status Screen
Controlling an iPod
An Apple
®
iPod
®
can be controlled from the APAD using an optional CEN-IPOD
iPod Connect.
The following assumes that the CEN-IPOD has been installed and that an iPod has
been connected as described in the latest version of the CEN-IPOD guide (Doc.
6404).
A typical iPod status screen is shown to the left. Press the Control soft button to
display the iPod control screen.