Installation guide

Crestron Adagio Entertainment System User Interface Devices
Out-Of-The Box Functionality Guide – DOC. 6493A Adagio Entertainment System: User Interface Devices • 3
adjust the room maximum volume setting between 70% and 100%.
Press the More button to display additional parameter adjustment
selections. Press the StrtV soft button to adjust the room starting
volume setting between 0% and 50%. Press the Mono soft button and
then press the Mono or Stereo (default) soft button to choose whether
the room audio should be delivered as mono or stereo.
 Press Menu to return to the tuner status screen.
AM/FM Tuner Status Screen
Selecting/Controlling Sources
The tuner status screen shown to the left is a typical default display for the room
where the APAD is located. You can:
• Press the Source soft button and use the Nav Wheel to scroll through the
available sources.
• Use the Nav Wheel soft button to activate the selected source, in this case,
the AM/FM tuner.
Tuner Source Control Screen
Controlling AM/FM Tuners
On the AM/FM tuner status screen, press the Control soft button to display the tuner
source control screen as shown in the figure on the left.
• Press the Manual soft button to access the radio tuner controls as shown to
the left.
Radio Tuner Controls
Preset Controls
AM/FM Signal Strength
Use the d or c soft buttons to scan for the next clear frequency below or
above the current station, or use the Nav Wheel to manually tune to a
desired station. Press the Nav Wheel soft button to enter the selection.
• Press the Preset soft button to access the list of current preset stations for
the selected tuner. If no presets have been set, the list will display a default
frequency setting as shown here in the preset controls screen.
Use the Nav Wheel to scroll through the list; press the Nav Wheel soft
button to enter a selection.
• To set a new Preset (or change an existing one), use the manual tuning
procedures to tune to a favorite station. Then, press the Preset soft button
and use the Nav Wheel to scroll through the list to the desired location and
press the Save soft button. The screen will display a prompt “Replace
preset with . .” asking if you wish to replace the current preset with the
selected frequency. Press the OK soft button to accept the replacement;
press Cancel to reject it.
• Press the Tech soft button to display the signal strength of the selected
station. This information is used during initial setup of the AM/FM
antenna, as discussed in the latest version of the appropriate guide
included with the tuner (Doc. 6461, 6462 or 6463).